The split was 1:50, with helium as the carrier gas at a flow rate of 1 ml/min, while the damping gas flow was 0.3 ml/min. The initial oven temperature was set to 40 °C for 1 min. The GC oven temperature program was as follows: 40 °C–220 °C, by ramping at 3 °C, and held at 220 °C for 20 min. The injector temperature was maintained at 220 °C and the transfer line was held at 220 °C. The detection was performed by a Thermo ITQ 900™ mass spectrometer in the EI mode (ionization energy of 70 eV, ion source temperature of 180 °C, emission

Sorafenib research buy current of 220 μA). The acquisition was made in full scanning mode (mass range 50–900 m/z; 3 scans/s). Maximum ionization time was 25 ms. A solvent delay time of 5 min (set off) was used to avoid overloading the mass spectrometer with hexane. Data collection, analysis and integration were performed using the software XCalibur™ (version 2.0.7). Areas were recorded under all detectable peaks, and percent composition was calculated by taking area of peak divided by total chromatogram area × 100. The volatile oil yield was determined by gravimetric means and calculated as percentage of starting fresh weight heartwood. For identification of constituents, mass spectra were compared with data from the National

CB-839 in vivo Institute of Standards and Technology (NIST, Washington DC, USA) and Dr. Duke’s Phytochemical and Ethnobotanical Database (http://www.ars-grin.gov/duke/). Statistical analysis was performed with SPSS software package (version 17) (SPSS Inc., Chicago, IL, USA). To understand the difference in values of parameters obtained from assays, one-way analysis of variance (ANOVA) was performed. Data provided were obtained from four inter-day runs of the GC–MS. The volatile yield

obtained from chipped heartwood was 0.045%, i.e., 45 mg g−1 dry weight. This yield is comparable to those obtained from transition Levetiracetam zone and central core of heartwood tissue i.e. 30–90 mg g−1 dry weight heartwood as reported.6 The results show that the extracted fraction is a complex mixture of 46 identified constituents which represented about 93.4% of the total volatile yield (Table 1). The dominant sesquiterpenoids in the volatile fraction were Z-α-santalol and epi-β-santalol, whereas the following constituents have been reported in sandalwood oil10 i.e., compounds – 20, 22, 25, 34, 36 and 38. Sesquiterpenoids were traced from their characteristic mass fragments of m/z 161 and m/z 204. To the best of our knowledge the occurrence of the following sesquiterpenoid compounds are reported for the first time from Indian sandalwood tree, i.e., compounds 18, 23, 24, 27, 29, 30 and 32 ( Table 1). Other lesser known sesquiterpenoids in sandalwood tree that have been identified include, germacrene A, bicyclogermacrene, and β-elemene.